NEC Express 5800 - Page 183

Hardware
183
5. Hold the hard disk drive and handle firmly and insert it into the slot.
6. Close the handle slowly. It clicks after it is locked.
7. Refer to “System Diagnostics” in Operation and Maintenance to perform the diagnostic
test when it is replaced offline (power-off).
8. Release the maintenance mode set in step 1.
IMPORTANT:
● Push it into the slot until the handle hook touches the frame.
● Hold the hard disk drive firmly and carefully to avoid dropping
or subjecting to interference or oscillation.
● Push the hard disk drive into the slot horizontally and slowly by
avoiding oscillation to the hard disk drive.
IMPORTANT:
Be careful not to catch
y
our fin
g
er between the handle and tra
y
.
NOTE:
Confirm that the handle hook is hooked to the frame.