Hardware
343
Default settings and their explanation of “Adapter Properties”
Item Default Description Change
Battery Backup Present
None
Displays battery Properties.
·When battery is installed: Present
·When battery is not installed: None
－
Set Factory Defaults No
[No]
Yes
Restores vendor's factory defaults. Prohibited *1
Cluster Mode
Disabled
－
Prohibited
Rebuild Rate
30
Recommended value: 30 Permitted
Patrol Read Rate
30
Recommended value: 30 Permitted
BGI Rate
30
Recommended value: 30 Permitted
CC Rate
30
Recommended value: 30 Permitted
Reconstruction Rate
30
Recommended value: 30 Permitted
Adapter BIOS
[Enabled]
Disabled
－
Prohibited
Coercion Mode
[None]
128MB-way
1GB-way
－
Prohibited
PDF Interval
300
Prohibited
Alarm Control Disabled
Enabled
Silence
Disabled: Does not issue an alarm. Prohibited
Cache Flush Interval
4
－
Prohibited
Spinup Drive Count
2
－
Prohibited
Spinup Delay
12
－
Prohibited
Stop On Error
[Disabled]
Enabled
－
Prohibited
Stop CC On Error
[No]
Yes
Specify the operation when an error
was
detection in Consistency Check.
No: Recover and resume.
Yes: Abort
Permitted
Maintain PD Fail History Disabled
[Enabled]
If the same HDD is inserted
again,then it is treated as an error.
Permitted
Schedule CC
Supported
Set the scheduled consistency
check.
Permitted
*1 Do not perform "Set Factory Defaults". If performed, the NEC's factory-set value will no
longer be restored.
To Next Page