547
・ oemnectrusthost
・ Format
oemnectrusthost [<on|off> [<ipaddr1> <ipaddr2> ... <ipaddr5>]]
・ Parameter
<on|off>: Enable or Disable
<ipaddr1> <ipaddr2> ... <ipaddr5>: IP Address (less than 6)
・ Description
This command restricts the network access to the management firmware by the IP
address.
When allowing the access from specified console terminal only, enable the setting by this
command. Because the setting is Disable by default, any IP address are allowed to access.
If no parameter is specified, the current setiing is displayed.
・ Example
-> oemnectrusthost
-> oemnectrusthost off
-> oemnectrusthost on 192.168.1.50 192.168.1.51
・ oemnecdate
・ Format
oemnectdate
・ Parameter
None
・ Description
Display the date and time of the management firmware.
IMPORTANT:
• The setting is applied immediately after executing this
command.
Even after the management firmware reset, the setting is valid.
To Next Page
Loading...
