NEC Express 5800 - Page 556

556
Settings:
0=Disable, 1=Enable
PatrolScrubbing Memory configuration
Settings:
0=Disable, 1=Enable
MemoryChannelSele
ction
Memory configuration
Settings:
0=Dual(non-hemi mode), 1=Quad(hemi mode)
MemoryInterleave Memory configuration
Settings:
0=Disable, 1=Intra, 2=Inter(4way), 3=Inter(Max)
MemoryAddressingSi
ze
Adressing Size
Settings:
0=44bit mode, 1=40bit mode
HyperThread
Hyper Thread（Not supported）
Settings:
0=Disable, 1=Enable
PCIeErrorRecovery
PCI Error Recovery（Not supported）
Settings:
0=Disable, 1=Enable
oemnec_cputhrottle The upper limit of the P-state of the processor.
The range to set is from the value of mode0 to the value
displayed by oemnec_cputhrottle_current.
Settings:
mode0=maximum number, mode1, mode2, mode3, mode4,
mode5, mode6, mode7=minimum number,
oemnec_cputhrottle_
current
The lower limit of the P-state of the processor.（Display only）
IMPORTANT:
•HyperThread and PCIeErrorRecovery are not supported.