Operation and Maintenance
643
(2) Enter <select> command on the command line of the System Diagnostics screen to select
the test required device.
- The followings are three ways of specifying the test device.
1. Specifying “Test device number”: Specifies the test device number of “Num” row
individually.
When specifying a device that “+” or “-” is added on the top of the device name, all the
devices under the tree is selected.
2. Specifying “Test device type”: Specifies the test device type of “Type” row. This
specifies the same type of devices.
3. Specifying “all”: Specifies all the test devices. # Specify <all> in general.
If there is no media in the DVD, the test for them will fail.
So, ignore the test result for them or do not execute the test for them.
The below is an example of specifying <Test device number>.
Check the executed result of <select> command with the <list> command.
TeDoLi> select 19
TeDoLi> list
+----+-+---------------------------------+------------+----+-------------+
| Num|*| Device List | Type |Prev| Status |
+----+-+---------------------------------+------------+----+-------------+
| 1| | MEMORY |MEMORY | | |
| 2|!|-MGM2 |MODULE | | |
| 3|!| -MGM2/MGB/GbE |NIC | | |
| 4| | Port1(eth1) |ETH-PORT | | |
| 5| | Port2(eth2) |ETH-PORT | | |
| 6|!|-PMM5 |MODULE | | |
| 7| | PMM5/PMB/PROC |CPU | | |
| 8|!|-PMM6 |MODULE | | |
| 9| | PMM6/PMB/PROC |CPU | | |
| 10|!|-BM |MODULE | | |
| 11|!| -BM/MB/PCI1 |SCSI(NoDev) | | |
| 12|!| Port1 |SCSI-PORT | | |
| 13|!| -BM/MB/PCI8 |NIC | | |
| 14| | Port1(eth0) |ETH-PORT | | |
| 15|!| -BM/MB/PCI9 |FC | | |
| 16|!| -Port1 |FC-PORT | | |
| 17| | SCSI-ID0 LUN0(iStorage 1000) |HDD | | |
| 18|!| Port2 |FC-PORT | | |
| 19|*| DV-28S-V |DVD | | |
+----+-+---------------------------------+------------+----+-------------+
To Next Page
Loading...
