Operation and Maintenance
647
16. End system diagnostics.
Enter <shutdown> command or <reboot> command in the command line of the System
Diagnostics screen to end the system diagnostics.
The following is an example of using <shutdown> command.
If the command is entered, the command confirmation message is displayed.
Enter “y” to shutdown the server.
· <shutdown> command and <reboot> command are available only when the system
diagnostics status is “Idle.”
· When <reboot> is entered, the system is rebooted.
17. Power off the server and unplug the power cord from the outlet.
18. Connect the LAN cable disconnected on the step 2.
19. Plug the power cord to the power outlet.
20. End the maintenance mode.
TeDoLi> shutdown
Are you sure you want to shut down the system?
Enter Y or N [N]: y
：
：
To Next Page
Loading...
