68
8．Connect with the remote console to make provide various settings.
Refer to chapter 2 “Hardware” - “Web Console Function”.
9．Power on the server and start Partition.
Refer to chapter 2 “Hardware” - “Power-On and Booting Server”.
10．Change BIOS settings according to configuration and purpose of the system.
Refer to chapter 2 “Hardware” - “BIOS Setup” and appendix C “Settings for each OS”.
11．Start WebBIOS and create virtual disks.
Refer to chapter 2 “Hardware” - “RAID System Configuration”.
12．Install the OS.
(1) Depending on the OS, BIOS settings are needed to be changed from the default settings.
Referring to appendix C “Settings for each OS”, change the BIOS settings so that it is
suitable for the OS which is being installed.
If the setting is changed, then reboot the system.
(2) Insert the OS install disk into the DVD Drive and reboot the system.
(3) Enter BIOS menu by pressing "SPACE key". From Boot Manager, select "Primary Slave
CDROM" and press "Enter". The OS installer starts.
Go on to the next OS setting-up operations.
IMPORTANT:
●Use WebBIOS only for creating a Virtual Disk to install OS.
IMPORTANT :
There is also a setup of the date or time among the setup of BIOS.
Be sure to check whether it is set up correctly.
To Next Page
Loading...
