Using the BayStack 450 10/100/1000 Series Switch
3-8 309978-D Rev 01
Reset to Default
Settings
Resets the switch to the factory default configuration settings (see “Reset to
Default Settings” on page 3-133). When you select this option a confirmation
prompt appears. Enter Yes to reset the switch to the factory default configuration
settings; enter No to abort the option. If the switch is participating in a stack
configuration, additional prompts allow you to reset a specific unit in the stack or
the entire stack. When you activate this option, the switch resets, runs a self-test,
and then displays the Nortel Networks logo screen.
Caution: If you choose the Reset to Default Settings option, all of your
configured settings will be replaced with factory default settings when you press
[Enter].
Achtung: Bei Auswahl des Befehls zur Rücksetzung auf die
Standardeinstellungen werden alle von Ihnen konfigurierten Einstellungen durch
die werkseitigen Standardeinstellungen ersetzt, wenn Sie die Eingabetaste
drücken.
Attention: Si vous restaurez la configuration usine, votre configuration courante
sera remplacée par la configuration usine dès que vous appuierez sur [Entrée].
Precaución: Si selecciona el comando Restaurar valores predeterminados,
todos los valores de configuración se sustituirán por las valores
predeterminados en fábrica al pulsar [Intro].
Attenzione: Nel caso in cui si selezioni la reimpostazione dei valori di default,
tutte le impostazioni configurate verranno sostituite dai default di fabbrica
premendo il tasto [Invio].
Logout Allows a user in a TELNET session, or a user working at a password-protected
console terminal, to terminate the session (see
“Logout” on page 3-136).
Table 3-1. Console Interface Main Menu options (continued)
Option Description
To Next Page
Loading...
