Using the BayStack 450 10/100/1000 Series Switch
3-32 309978-D Rev 01
Table 3-9. MAC Address Security Port Configuration Screen Fields
Field Description
Unit Allows you to select the unit number (when stacking is configured) to view or
configure. To view or configure another unit, type its unit number and press
[Enter], or press the spacebar to toggle the unit numbers.
Port Indicates the switch port numbers that correspond to the field values in that
row of the screen (for example, the field values in row 2 apply to switch port 2).
The values that you set in the Switch row will affect all switch ports and, when
the switch is part of a stack, the values that you set in the Stack row will affect
all ports in the entire stack.
Trunk The read-only data displayed in this column indicates the MultiLink Trunks that
correspond to the switch ports specified in the Trunk Members fields of the
Trunk Configuration screen.
Security Allows you to enable or disable security for the specified port.
Note: If an (optional) BayStack 450-2M3/2S3 MDA is installed in your switch,
the Security field value you set for a single LEC VPort applies automatically to
the three remaining LEC VPorts.
Default Disabled
Range Disabled, Enabled
To Next Page
Loading...
Need help?
General