Using the Console Interface
309978-D Rev 01 3-109
Display Hardware Units
The Hardware Unit Information screen (Figure 3-42) lists the switch models,
including any installed MDA and Cascade modules, that are configured in your
standalone or stack configuration.
Choose Display Hardware Units (or press h) from the main menu to open the
Hardware Unit Information screen.
Renumber units with
new setting?
Specifies whether to start the renumbering process (default is No). Use the
spacebar to toggle the selection to Yes. The Unit LEDs display the new numbering
order.
Renumbering resets the switch with the current configuration values.
When you select this option, the switch resets, runs a self-test, then displays the
Nortel Networks logo screen. After you press [Ctrl]-Y at the screen prompt, the
console screen temporarily displays the (standalone) BayStack 450 main menu.
Then, within 20 seconds, the console screen refreshes and displays the main
Menu for the stack configuration.
Default No
Range No, Yes
Table 3-37. Renumber Stack Units Screen Options (continued)
Option Description