Nortel BayStack 450-24T - Configuration File; Figure 3-49. Configuration File Download;Upload Screen

Using the Console Interface
309978-D Rev 01 3-125
Configuration File
The Configuration File Download/Upload screen (Figure 3-49) allows you to
store your switch/stack configuration parameters on a TFTP server.
You can retrieve the configuration parameters of a standalone switch or an entire
stack and use the retrieved parameters to automatically configure a replacement
switch or stack. Certain requirements apply when automatically configuring a
switch or stack using this feature (see
“Requirements” on page 3-126). You must
set up the file on your TFTP server and set the file name read/write permission to
Enabled before you can save the configuration parameters.
Although most configuration parameters are saved to the configuration file,
certain parameters are not saved (see
Table 3-45 on page 3-127).
Choose Configuration File (or press g) from the main menu to open the
Configuration File Download/Upload screen.
Figure 3-49. Configuration File Download/Upload Screen
Table 3-44 describes the Configuration File Download/Upload screen fields.
Configuration File Download/Upload
Configuration Image Filename: [ ]
TFTP Server IP Address: [ xxx.xxx.xxx.x ]
Copy Configuration Image to Server: [ No ]
Retrieve Configuration Image from Server: [ No ]
Enter text, press <Return> or <Enter> when complete.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.