Nortel BayStack 450-24T - Configuring MultiLink Trunks

Using the BayStack 450 10/100/1000 Series Switch
E-18 309978-D Rev 01
Configuring MultiLink Trunks
To create or modify a MultiLink trunk, follow the flowchart in Figure E-17.
Choose MultiLink Trunk Configuration (or press t) from the MultiLink Trunk
Configuration Menu to open the MultiLink Trunk Configuration screen.
Figure E-17. Configuring MultiLink Trunks
Yes
No
No
Configure STP field.
Enable Trunk Status field
(see "MultiLink Trunking
Configuration Rules").
Configure trunk members
(see "MultiLink Trunking
Configuration Rules").
BS450114A
Are all
trunk members
configured?
Is trunk
STP Enabled?
Yes
Is trunk
Enabled?
Yes
No
Done
MultiLink Trunk
Configuration screen