Using the Console Interface
309978-D Rev 01 3-121
Software Download
The Software Download screen (Figure 3-48) allows you to revise the BayStack
450 switch software image that is located in nonvolatile flash memory.
To download the BayStack 450 switch software image, you need a properly
configured Trivial File Transfer Protocol (TFTP) server in your network, and an
IP address for the switch (or stack, if configured). To learn how to configure the
switch or stack IP address, see
“IP Configuration/Setup” on page 3-9.
You can monitor the software download process by observing the BayStack 450
switch LEDs (see
“LED Indications During the Download Process” on
page 3-123).
Caution: Do not interrupt power to the device during the software download
process. If the power is interrupted, the firmware image can become corrupted.
Achtung: Unterbrechen Sie die Stromzufuhr zum Gerät nicht, während die
Software heruntergeladen wird. Bei Unterbrechung der Stromzufuhr kann das
Firmware-Image beschädigt werden.
Attention: Ne pas couper l'alimentation de l'appareil pendant le chargement
du logiciel. En cas d'interruption, le programme résident peut être endommagé.
Precaución: No interrumpa la alimentación del dispositivo durante el
proceso de descarga del software. Si lo hace, puede alterar la imagen de la
programación (firmware).
Attenzione: Non interrompere l'alimentazione elettrica al dispositivo durante
il processo di scaricamento del software. In caso di interruzione, l'immagine
firmware potrebbe danneggiarsi.
To Next Page
Loading...
Need help?
General