ATM Overview
309978-D Rev 01 D-13
Configuration Rules
This section summarizes important configuration rules for your
BayStack 450-2M3/2S3 MDA.
Mixed Stack Configurations
Your BayStack 450-2M3/2S3 MDA does not support Business Policy Switches.
BayStack 450 Switches configured with BayStack 450-2M3/2S3 MDAs cannot
operate in mixed stack configurations that include Business Policy Switches.
Initial Configuration
During the initial configuration of the BayStack 450-2M3/2S3 MDA, you must
perform the following steps:
1. Configure the VLAN memberships for the four LECs in the VLAN
Configuration screen.
2. Set the LEC State field to Enabled in the LEC Configuration screen.
See “Configuring the BayStack 450-2M3/2S3 MDAs” on page E-15 for
flowcharts that detail the configuration steps for your BayStack 450-2M3/2S3
MDA.
Enabling a LEC
Every LEC requires the following:
• A unique ELAN name
The ELAN name default value is: default
• An Actual Physical Port number (A1 or A2)
The physical port number default value is: A1
• A port-based VLAN.
You must assign the LEC to a new or existing port-based VLAN (using the
VLAN Configuration screen) the first time a LEC is assigned, or whenever
you issue the Reset to Default Settings command. In all other cases, a LEC’s
VLAN membership is saved and restored following subsequent switch power
cycles.
To Next Page
Loading...
Need help?
General