Using the BayStack 450 10/100/1000 Series Switch
3-4 309978-D Rev 01
Map of CI Menus and Screens
Figure 3-1 shows a map of the CI screens. The remainder of this chapter describes
the CI screens and their fields, beginning with the main menu.
Figure 3-1. Map of Console Interface Screens
The CI screens for your specific switch model will show the correct model name
in the main menu title and the correct number of ports and port types in the Port
Configuration screen.
Note: The field values shown in the CI screens in this section are provided as
examples only.
IP Configuration/Setup
SNMP Configuration
System Characteristics
Switch Configuration
Console/Comm Port Configuration
Identify Unit Numbers
Renumber Stack Units
Display Hardware Units
Spanning Tree Configuration
TELNET/SNMP Mgr List Configuration
Software Download
Configuration File
Display Event Log
Save Current Settings
Reset
Reset to Default Settings
Logout
Main Menu
MAC Address Table
MAC Address-Based Security
EAPOL Security Configuration
VLAN Configuration
Port Configuration
High Speed Flow Control
Configuration
MultiLink Trunk Configuration
Port Mirroring Configuration
Rate Limiting Configuration
IGMP Configuration
Display Port Statistics
Clear All Port Statistics
ATM Configuration
Spanning Tree Port Configuration
Display Spanning Tree Switch Settings
VLAN Configuration
VLAN Port Configuration
VLAN Display by Port
Traffic Class Configuration
MultiLink Trunk Configuration
MultiLink Trunk Utilization
BS45087B
1
1
IGMP Configuration
Display Multicast Group Membership
MAC Address Security Configuration
MAC Address Security Port Configuration
MAC Address Security Port Lists
MAC Address Security Table
2
Only appears when the switch is participating in a stack configuration.
Only appears when a gigabit MDA is installed in one or more units in a stack configuration.
Only appears when an ATM MDA is installed in one or more units in a stack configuration.
1
2
3
3
To Next Page
Loading...
Need help?
General