R&S FSW Series - Page 1089

Remote Commands
R&S
®
FSW
1089User Manual 1173.9411.02 ─ 43
//--------------Performing the Measurement-----
//Select single sweep mode.
INIT:CONT OFF
//Initiate a basic frequency sweep and wait until the sweep has finished.
INIT;*WAI
//---------------Retrieving Results-------------
//Return the trace data (default screen configuration)
TRAC:DATA? TRACe1
14.7.6.3 Setting up Probes
Modular probes can be connected to the RF input connector of the R&S FSW.
For details see Chapter 8.2.1.1, "Using Probes", on page 358.
Probes can also be connected to the optional "Baseband Input" connectors, if the Ana-
log Baseband interface ( option R&S FSW-B71) is installed.
[SENSe:]PROBe<pb>:ID:PARTnumber?........................................................................ 1089
[SENSe:]PROBe<pb>:ID:SRNumber?............................................................................1090
[SENSe:]PROBe<pb>:SETup:ATTRatio..........................................................................1090
[SENSe:]PROBe<pb>:SETup:CMOFfset........................................................................ 1090
[SENSe:]PROBe<pb>:SETup:DMOFfset........................................................................ 1091
[SENSe:]PROBe<pb>:SETup:MODE............................................................................. 1091
[SENSe:]PROBe<pb>:SETup:NAME?............................................................................1092
[SENSe:]PROBe<pb>:SETup:NMOFfset........................................................................ 1092
[SENSe:]PROBe<pb>:SETup:PMODe........................................................................... 1093
[SENSe:]PROBe<pb>:SETup:PMOFfset........................................................................ 1093
[SENSe:]PROBe<pb>:SETup:STATe?............................................................................1094
[SENSe:]PROBe<pb>:SETup:TYPE?.............................................................................1094
[SENSe:]PROBe<pb>:ID:PARTnumber?
Queries the R&S part number of the probe.
Suffix:
<pb>
.
1..n
Selects the connector:
1 = Baseband Input I
2 = Baseband Input Q
3 = RF
Return values:
<PartNumber>
Example: //Query part number
PROB3:ID:PART?
Usage: Query only
Manual operation: See "Part Number" on page 372
Setting Basic Measurement Parameters