R&S FSW Series - Page 1158

Remote Commands
R&S
®
FSW
1158User Manual 1173.9411.02 ─ 43
The step size defines the distance the marker moves when you move it with the rotary
knob.
It therefore takes effect in manual operation only.
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<StepSize> STANdard
the marker moves from one pixel to the next
POINts
the marker moves from one sweep point to the next
*RST: POINts
Example:
CALC:MARK:X:SSIZ STAN
Sets the marker step size to one pixel.
Manual operation: See "Marker Stepsize" on page 523
14.8.3.3 Configuring and Performing a Marker Search
The following commands control the marker search.
CALCulate<n>:MARKer<m>:LOEXclude........................................................................ 1158
CALCulate<n>:MARKer<m>:PEXCursion....................................................................... 1159
CALCulate<n>:MARKer<m>:X:SLIMits[:STATe]...............................................................1159
CALCulate<n>:MARKer<m>:X:SLIMits:LEFT.................................................................. 1160
CALCulate<n>:MARKer<m>:X:SLIMits:RIGHt.................................................................1160
CALCulate<n>:MARKer<m>:X:SLIMits:ZOOM[:STATe].................................................... 1161
CALCulate<n>:THReshold............................................................................................ 1161
CALCulate<n>:THReshold:STATe..................................................................................1161
CALCulate<n>:MARKer<m>:LOEXclude <State>
This command turns the suppression of the local oscillator during automatic marker
positioning on and off (for all markers in all windows).
Suffix:
<n>
.
irrelevant
<m> irrelevant
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
CALC:MARK:LOEX ON
Manual operation: See "Exclude LO" on page 525
Analyzing Measurements (Basics)