R&S FSW Series - Page 724

General Instrument Setup
R&S
®
FSW
724User Manual 1173.9411.02 ─ 43
Parameter 1 / Parameter 2
The coupled parameters, markers, or lines.
Remote command:
INSTrument:COUPle:USER<uc>:NEW? on page 1321
State
Enables or disables the coupling.
Remote command:
INSTrument:COUPle:USER<uc>:STATe on page 1324
Direction
Determines which parameter controls the other.
"<-"
Parameter 2 controls parameter 1. If parameter 2 is changed, param-
eter 1 is adapted. If parameter 1 is changed, parameter 2 remains
unchanged.
Remote command:
INST:COUP:USER:REL RTOL
"->"
Parameter 1 controls parameter 2. If parameter 1 is changed, param-
eter 2 is adapted. If parameter 2 is changed, parameter 1 remains
unchanged.
Remote command:
INST:COUP:USER:REL LTOR
"<->"
Both parameters are equal. If one parameter is changed, the other
parameter is adapted and vice versa.
Remote command:
INST:COUP:USER:REL BID
Delete coupling definition
Deletes the selected coupling definition permanently.
Remote command:
INSTrument:COUPle:USER<uc>:REMove on page 1324
Info
Shows information for the selected coupling, for example, restrictions regarding the
coupling.
Note that usually, no information is displayed.
Remote command:
INSTrument:COUPle:USER<uc>:INFO on page 1320
Delete All
Deletes all current coupling definitions. Parameters are no longer coupled.
Remote command:
INSTrument:COUPle:USER<uc>:REMove on page 1324
Add New User Coupling
Opens a dialog box to create a new user-defined coupling definition.
Synchronizing Measurement Channel Configuration