4.Replacement and Adjustment
373
• [Receiver] in [User Tools] -> [Machine Features] -> [Facsimile Features] -> [Reception
Settings] -> [Reception File Settings] -> [Output Mode Switch Timer].
• [Store: Notify Destination] in [User Tools] -> [Machine Features] -> [Facsimile Features] ->
[Reception Settings] -> [Output Mode Switch Timer].
• All the destination information is shown on the display.
• In the fax settings, address book data is stored with entry IDs, which the system
internally assigns to each data. The entry IDs may be changed due to re-assigning in
backup/restore operations.
4. Make sure that there is no transmission standby file. If any standby file exists, ask the
customer to delete it or complete the transmission.
8. Turn OFF the main power and unplug the power cord.
9. Press the main power switch again to discharge the residual charge.
10. Replace the NVRAM with a new one.
11. Turn ON the main power.
• For P 800/801, SC995 will be displayed after turning ON the main power.
• For IM 550F/600F/600SRF, SC995 might be internally issued after turning ON the main
power.
• After turning ON the main power, SC870 will occur and the address book data will be
cleared.
12. For IM 550F/600F/600SRF, change the following SP settings for the operation panel after turning
ON the main power.
• SP5-748-101: (OpePanel Setting: Op Type Action Setting): Change bit 0 from "0" to "1".
• SP5-748-201: (OpePanel Setting: Cheetah Panel Connect Setting): Change the value from "0"
to "1".
13. For IM 550F/600F/600SRF, change the Flair API SP values.
• SP5-752-001 (Copy FlairAPIFunction Setting): Change bit 0 from "0" to "1".
• SP1-041-001 (Scan:FlairAPI Setting) in Scanner SP: Change bit 0 from "0" to "1".
• SP3-301-001 (FAX:FlairAPI Setting) in Fax SP: Change bit 0 from "0" to "1".
14. Turn OFF/ON the main power with the SD card where the NV-RAM data has been uploaded in SD
slot 2.
15. Download the NV-RAM data stored in the SD card to the brand-new NV-RAM using SP5-825-001
(NV-RAM Data Download).
• The download will take a few minutes.
16. Turn OFF the main power and remove the SD card from SD Card Slot 2.
17. Turn ON the main power.
To Next Page
Loading...
