4.Replacement and Adjustment
454
[B]: 3 mm to the left
[C]: 1.5 mm to the left
[D]: Center position
[E]: 1.5 mm to the right
[F]: 3 mm to the right
2. Insert the screw to one of the five slits [G] which is aligned with a screw hole.
10. Put a screwdriver through the hole [A] and loosen the screw that fixes the finisher.
11. Remove the screw and slide the finisher [A] to the left or right according to the explanation in step
7.
12. After moving the finisher, reattach the screw in a new position according to the explanation in step
To Next Page
Loading...
