Error Name/Error Condition/Major Cause/Solution
• Mainboard defective
Replace the main board.
Error Name/Error Condition/Major Cause/Solution
Paper Feed Tray Lift Motor (M8) Error (Tray 5)
After the paper feed tray 5 is set, the paper feed tray lift sensor does not turn on
within 10 seconds. This SC is issued if a problem is detected four times
consecutively.
• The bottom plate of the paper feed tray defective
• Connector disconnected or defective
• Drive transmission of the Paper feed tray lift motor (M8) defective
• Paper feed tray lift motor (M8) defective
• Mainboard defective
• The bottom plate of the paper feed tray defective
Check the bottom plate of the paper feed tray. If the bottom plate does not
move smoothly, repair or replace the paper feed tray.
• Connector disconnected or defective
Reconnect the following connector. Then perform a conduction inspection. If
there is no conduction, replace the connector.
• Paper Feed Tray Lift Motor (M8) – Main Board connector
• Drive transmission of the Paper feed tray lift motor (M8) defective
Check the gears. If any gears are damaged, replace them.
• Paper feed tray lift motor (M8) defective
Replace the Paper feed tray lift motor (M8).
• Mainboard defective
Replace the main board.
Error Name/Error Condition/Major Cause/Solution
Paper Feed Tray Error (Tray 5)
The error signal is detected for 2 seconds consecutively after the paper feed motor
is activated.
• Connector defective or disconnected
• Drive transmission of the paper feed motor defective
• Paper feed motor defective
• Mainboard defective
• Connector defective or disconnected
Reconnect the following connector. Then perform a conduction inspection. If
To Next Page
Loading...
