Rohde & Schwarz CMW 500 - Page 12

R&S
®
CMW 500 Contents
Operating Manual 1202.3986.32 – 03 II-8
7.3.1.1 Key Features................................................................................................................164
7.3.1.2 Generating a CW Signal ..............................................................................................165
7.3.1.3 Generating a Dual-Tone Signal ...................................................................................165
7.3.1.4 Using the Generator List Mode....................................................................................166
7.3.2 Programming the Power Measurement .......................................................................167
7.3.2.1 Key Features................................................................................................................167
7.3.2.2 Specifying General Measurement Settings .................................................................168
7.3.2.3 Specifying Measurement-Specific Settings .................................................................168
7.3.2.4 Performing a Single Shot Measurement......................................................................169
7.3.2.5 Configuring the List Mode............................................................................................169
7.3.2.6 Single Shot and Continuous Power Measurements ....................................................170
7.3.3 Programming the External Power Sensor Measurement ............................................170
7.3.3.1 Key Features................................................................................................................171
7.3.3.2 Performing a Single Shot Measurement......................................................................171
7.3.3.3 Zeroing the External Sensor ........................................................................................172
7.3.3.4 Continuous Sensor Measurement ...............................................................................172
7.4 GPRF Command Reference......................................................................................172
7.4.1 General Measurement Settings ...................................................................................172
7.4.1.1 Command Groups (General Measurement Settings) ..................................................173
7.4.1.2 Signal Routing..............................................................................................................173
7.4.1.3 Analyzer Settings .........................................................................................................174
7.4.2 GPRF Generator Commands ......................................................................................175
7.4.2.1 Command Groups (RF Generator) ..............................................................................175
7.4.2.2 Generator Control and States......................................................................................176
7.4.2.3 Signal Routing..............................................................................................................176
7.4.2.4 Constant-Frequency Settings ......................................................................................177
7.4.2.5 Baseband Settings.......................................................................................................178
7.4.2.6 List Mode Settings .......................................................................................................179
7.4.3 Power Measurement Commands ................................................................................182
7.4.3.1 Command Groups (Power Measurement)...................................................................183
深圳德标仪器 135-1095-0799