Sel 2414 - MET RTD Metering; MET Temp Metering; MET RA Remote Analog Metering; MET MV Math Variable Metering

7.19
Date Code 20130214 Instruction Manual SEL-2414 Transformer Monitor
Communications
ASCII Commands
MET RTD Metering
Use the MET RTD command to display values measured by an internal RTD
card or external SEL-2600 device.
MET Temp Metering
Use the MET Temp command to display TC or RTD values measured by the
Internal General Purpose Temperature Card.
MET RA Remote Analog Metering
Use the MET RA command to display remote analog values sent by a remote
device.
MET MV Math Variable Metering
Use the MET MV command to display math variable values calculated by the
device.
MET F k Fundamental Metering
Use the MET F k command to display fundamental metering data.
The MET F k command displays instantaneous magnitudes, and angles if appli-
cable, of the following quantities:
➤ Currents
➤ Voltages
➤ Power
➤ Power Factor
➤ Sequence
➤ Frequency
Command Description Access Level
MET RTD n Display RTD values. 1
Command Description Access Level
MET Temp n Display RTD/TC values from Internal General
Purpose Temperature Card.
1
Command Description Access Level
MET RA n Display Remote Analog (RA) values. 1
Command Description Access Level
MET MV Display Math Variable (MV) values. 1
Command Description Access Level
MET F k Display instantaneous metering data k times. 1