7.29
Date Code 20130214 Instruction Manual SEL-2414 Transformer Monitor
Communications
ASCII Commands
TRIGGER Command
(Trigger Event
Report)
Use the TRI command to trigger an event report, as shown in Table 7.53.
When you issue the TRI command, the SEL-2414 responds, Triggered. If the
event did not trigger within 1 second, the device responds,
Did not trigger. See
Section 9: Analyzing Events for further details on event reports.
Table 7.53 TRIGGER Command (Trigger Event Report)
Command Description Access Level
TRI Trigger event report data capture. 1
To Next Page
Loading...
