Techman Robot TM Palletizing Operator - 2.4 Overall Safety Warning

TM Palletizing Operator User’s Manual Product Version: 1.0 / Document Version: 1.0 30
 The product must be used according to its intended use.
 If the installation and application does not observe human-robot collaboration regulations of the safety
regulations, the user is responsible for providing safety barriers around the robot to prevent anyone from
accidentally coming into contact with the robot when it is in motion.
 If any local or national electrical regulation requires, power to the robot and its power supply must be locked
out and tagged out, or have means to control hazardous energy or implement energy isolation before any
maintenance is performed.
 Dispose of the product in accordance with the relevant rules and regulations of the country or area
where the product is used.
2.4 Overall Safety Warning
These safety warnings are relevant for the entire manual.
DANGER:
1. Before transporting, installing, operating, maintaining and repairing this product, make sure to read the product
specification and operation manual in detail. Confirm that all the conditions comply with the requirements of the
specification and the Manual, to avoid unintended accidents (for example: improper operation or conditions of
use that exceed the product specification) that may result in injury to personnel.
2. Before installing and using this product, the integrator must perform a risk assessment and implement risk
reduction measures.
3. Users shall create procedures for emergency and abnormal situations.
4. Before using this product, make sure that the machinery has at least one emergency stop device capable of
stopping the motion of robot in the event of an accident, and must confirm that there is no abnormality in the
function and operation of the device.
5. Before performing maintenance or service record the details of each setting for the robot for normal operation.
Make sure that each setting satisfies the original conditions before resuming normal operation, including but not
limited to:
 Safety Software Settings
 Safety I/O
 Preset operation project
 TCP Settings
 I/O Settings
 I/O Wiring