Techman Robot TM Palletizing Operator - Encountering Non-Flat Surfaces; Figure 70: TM Palletizing Operator Transportation (4;4)

TM Palletizing Operator User’s Manual Product Version: 1.0 / Document Version: 1.0 96
For wider jack lifts (typically 685mm wide), insert the jack lift into the side slot to lift the operator.
Figure 70: TM Palletizing Operator Transportation (4/4)
WARNING:
1. Avoid transporting the palletizing operator through damp environment.
2. Remove all of the external I/O connections of the TM Palletizing Operator.
3. Remove all air lines or external power lines connected to the equipment before transporting
it.
4. Remove all of the connections to external devices / external storage devices through any
interface.
5.5.1 Encountering Non-Flat Surfaces
When encountering non-flat surfaces, apply a wrench to adjust the leveling mounts in order to avoid
wobbling.
1. Rotate upper hex nut clockwise to loosen the leveling mounts
2. Rotate lower hex nut clockwise to lower the leveling mounts
3. Rotate lower hex nut counterclockwise to raise the leveling mounts
4. Rotate upper hex nut counterclockwise to tighten the leveling mounts