Xerox PHASER 6010 - Page 149

Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 3-13
Error Messages and Codes
033-787 Memory Full
033-787 Fax
Job Failure
Press OK
<Calling Table Full>
The Calling Table is full.
3-66
033-788 Memory Full
033-788 Fax
Job Failure
Press OK
<Memory Full>
Exceeds the memory capacity.
3-64
034-700 Busy
034-700 Fax
Job Failure
Press OK
<FAX Busy>
FAX called number is busy.
3-67
034-701 No Dial Tone
034-701 Fax
Job Failure
Press OK
<No Dial Tone>
No dial tone on the phone line.
3-67
034-702
to
034-711
Communication Fail
034-7xx Fax
Job Failure
Press OK
Communication Errors 3-68
034-750
to
034-768
Communication Fail
034-7xx Fax
Job Failure
Press OK
RX Communication Errors 3-69
041-340 041-340
Code:xxxxxxxx
Restart Printer
<NVRAM Error>
The operation error of NVM
(read/write check error etc.) is
detected.
3-70
042-325 Motor Error
Restart Printer
Motor Error 3-71
042-358 042-358 Printer
Restart Printer
Contact Support
If Message Returns
<Fan Motor Failure>
MCU detects an error upon
receiving error signal from the
Fan Motor.
3-72
042-372 Deve Mode Error
Restart Printer
<Deve Mode Change Failure>
Deve Mode Change failure is
detected.
3-73
061-370 061-370 Printer
Code:xxxxxxxx
Restart Printer
<LPH Failure>
LPH failure is detected.
3-75
062-321 062-321 System
Restart Printer
<Carriage Motor Error>
Carriage Motor error is detected.
3-76
062-322 <No message, only
appears in error log>
Scanner drive calibration failed. 3-77
062-360 062-360 System
Restart Printer
<Image Processing Error>
Image Processor error is detected.
3-110
Error Message Summary (Continued)
Error
Code
Error Message LCD Error Description Go to