Xerox PHASER 6010 Service Manual

3-90 Xerox Internal Use Only Phaser 6000/6010 and WC 6015 MFP
Error Messages and Codes
Rear Cover Open
A Rear Cover Open error was detected.
Applicable Error
• 077-304: Rear Cover Open
Initial Actions
• Open and close the Rear Door.
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Rear Door, PL1.1.6
■ Interlock Switch, PL1.1.12
■ LVPS, PL7.2.1
■ MCU Board, PL7.2.2
■ “Map 3 - Phaser 6000/6010” on
page 10-9
■ “Phaser 6000/6010 LVPS” on
page 10-11
■ “Map 3 - WorkCentre 6015 MFP” on
page 10-23
■ “WorkCentre 6015 MFP LVPS” on
page 10-25
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Visually inspect the Rear Door for
damage.
Is the Rear Door damaged?
Replace the
Rear Door (for
Phaser
6000/6010, or
page 8-24 for
WorkCentre
6015 MFP).
Go step 2.
2 Enter diagnostic mode and run the
Cover Open Sensor test (see
page 4-11).
Does the number on the display
increase by 1 each time the door is
opened?.
Go to step 4. Go to step 3.
3 Replace the Interlock Switch
(page 8-17 for Phaser 6000/6010, or
page 8-26 for WorkCentre 6015
MFP)?
Does the error persist?
Go to step 4. Complete.

Xerox PHASER 6010 Specifications

General

Print Technology	Laser
Print Speed	Up to 12 ppm color / 15 ppm black
Print Resolution	1200 x 2400 dpi
Monthly Duty Cycle	Up to 30, 000 pages
Standard Paper Capacity	150 sheets
Memory	128 MB
Paper Output Capacity	100 sheets
Duplex Printing	Manual
Maximum Paper Capacity	150 sheets
Supported Operating Systems	Windows, Mac OS, Linux
Connectivity	USB 2.0
Weight	24.3 lbs