Xerox PHASER 6010 - No Paper Sensor; Registration Pinch Roller

Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 8-57
Service Parts Disassembly
No Paper Sensor
PL2.2.23
Note
This procedure applies to the 6010N and WorkCentre 6015 MFP.
1. Remove the xerographics assembly (page 8-68).
2. Release the 3 hooks, and remove the No Paper Sensor.
Registration Pinch Roller
PL2.3.2
1. Remove the Main Paper Tray Cover (Phaser 6000/6010 page 8-7; WorkCentre
6015 MFP page 8-29).
2. Remove the Front Cover (Phaser 6000/6010 page 8-8; WorkCentre 6015 MFP
page 8-34).
3. Open the Rear Door.
4. Remove the Left Side Cover (Phaser 6000/6010 page 8-10; WorkCentre 6015
MFP page 8-29).
5. Remove the Top Cover (Phaser 6000/6010 page 8-11; WorkCentre 6015 MFP
page 8-22).
6. Remove the Rear Cover (Phaser 6000/6010 page 8-15; WorkCentre 6015 MFP
page 8-24).
7. Remove the Toner Door (Phaser 6000/6010 page 8-19; WorkCentre 6015 MFP
page 8-27).
8. Remove the Cleaner Assembly (page 8-79).
s6000-216
P/J121