Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 10-19
Wiring
WorkCentre 6015 MFP Printer Plug/Jack Designations
The Plug/Jack Locator diagrams show the P/J locations within the WorkCentre
6015 MFP. Use these illustrations to locate connections called out in the
troubleshooting procedures presented in Sections 3, 4, and 5.
1. Locate the P/J connector designator in the first column of the table.
2. With this information, go to the map listed in the Map column.
3. Use the coordinates to locate the connection indicated on the map by its P/J
designation number.
4. The Remarks column provides a brief description of each connection.
WorkCentre 6015 MFP Plug and Jack Designators
P/J Map Coordinates Remarks
1 2 I-124 Connects LED Driver Board and LED/MCU Cable
1 2 I-125 Connects LED Driver Board and IP Board
1 2 J-117 Connects IP Board and Harness Assembly LVES AIO
2 2 H-119 Connects IP Board and Fax Board
2 2 I-119 Not connected
2 2 J-125 Connects LED Driver Board and the LPH (M)
2 2 J-126 Connects USB Board to Harness Assembly USB Front
3 2 J-125 Connects LED Driver Board and the LPH (Y)
4 2 J-125 Connects LED Driver Board and the LPH (K)
5 2 J-125 Connects LED Driver Board and the LPH (C)
6 2 I-117 Connects IP Board and Scanner (Control Panel)
8 2 J-118 Connects IP Board and Image Processor Harness
9 2 J-118 Connects IP Board and LED Driver Board Harness
10 3 I-133 Connects MC Board and Developer Drive Assembly
11 2 H-119 Connects IP Board and Harness Assembly USB Front
12 2 H-118 Connects IP Board and Wi-Fi Board
12 3 J-134 Connects MCU Board and Harness Assembly RKN
SNS
13 3 H-133 Connects MCU Board and Harness Assembly DCKR
14 2 H-118 Not connected
14 3 J-133 Connects MCU Board and Harness Assembly CTD1
TRO
15 3 H-133 Not connected
16 2 H118 Connects IP Board and Scanner
16 3 I-133 Connects MCU Board and Harness Assembly Main
MOT
17 3 H-134 Connects MCU Board and LVPS
18 3 I-134 Connects MCU Board and Fuser
19 3 I-133 Connects MCU Board and Feed Solenoid
To Next Page
Loading...
