Xerox PHASER 6010 - Waiting for Continue Key to be Pressed after Reloading Paper

Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 3-79
Error Messages and Codes
Waiting for Continue Key to be Pressed After Reloading Paper
The printer is in manual duplex mode waiting for user interaction.
Applicable Error
• 075-921: Waiting for OK key to be pressed after reloading paper.
Initial Actions
• Remove the paper from the Output Tray, put it back in to the paper tray, and
press OK.
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ IP Board, PL7.1.9
■ MCU Board, PL7.2.2
■ “Map 2 - Phaser 6000/6010” on
page 10-8
■ “Phaser 6000/6010 Image Processor
Board” on page 10-18
■ “Map 2 - WorkCentre 6015 MFP” on
page 10-22
■ “WorkCentre 6015 MFP Image
Processor Board” on page 10-32
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Reseat the connectors on the IP and
MCU Boards then cycle system
power.
Does the error persist?
Go to step 2. Complete.
2 Replace the IP Board (page 8-114).
Does the error persist?
Replace the
MCU Board
(page 8-121).
Complete.