Xerox PHASER 6010 - Firmware Error 024-340

Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 3-49
Error Messages and Codes
Firmware Error 024-340
A firmware error has occurred.
Applicable Error
• 024-340: Firmware Error
Initial Actions
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ MCU Board, PL7.2.2 ■ “Phaser 6000/6010 System Wiring” on
page 10-10
■ “WorkCentre 6015 MFP System Wiring”
on page 10-24
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Replace the MCU Board
(page 8-121).
Does the error persist?
Perform the
Electrical Noise
check
(page 4-66).
Complete.