Xerox PHASER 6010 - LED Driver Board and Harness

Phaser 6000/6010 and WC 6015 MFP Xerox Internal Use Only 8-107
Service Parts Disassembly
LED Driver Board and Harness
PL7.1.5, PL7.1.7A~B
1. Remove the Main Paper Tray Cover (Phaser 6000/6010 page 8-7; WorkCentre
6015 MFP page 8-29).
2. Remove the Front Cover (Phaser 6000/6010 page 8-8; WorkCentre 6015 MFP
page 8-34).
3. Open the Rear Door.
4. Remove the Left Side Cover (Phaser 6000/6010 page 8-10; WorkCentre 6015
MFP page 8-29).
5. If present, remove the Wi-Fi Assembly (page 8-103).
6. Remove the Top Cover (Phaser 6000/6010 page 8-11; WorkCentre 6015 MFP
page 8-22).
7. Remove the Fan (page 8-106).
8. Disconnect the connectors on the MCU Board as shown in the following
illustration.
s6000-119
P/J14
P/J12
P/J23
P/J25
P/J19
P/J10
P/J16