Xerox Versant 4100 Press - Test Print; Tips for Using the Test Print Option

2. Go the print server and check the main or home window for a similar message:
• If a message exists, follow the information provided on the print server to correct the stock
mismatch issue, then continue to the next step.
• If a message does not exist, continue to the next step.
3. Load the stock in the tray.
If the User Interface on the press displays a mismatch message, to correct the mismatch, use the
Stock Wizard.
4. Close the tray.
The Stock Wizard opens.
5. To change the Tray Properties to match the contents of the tray, follow the stock setup steps in
the Stock Wizard.
6. Resolve all tray and stock mismatch messages.
7. Start your print job.
TTeesstt PPrriinntt
The Test Print option runs sample prints of the specific stock loaded in a tray. Use these sample prints
to assess whether the loaded stock prints correctly with the selected stock properties, including any
selected Advanced Stock Setup options. The test pattern that is used for the sample prints can vary
depending on which Test Print option is selected and used.
The Test Print option is available with the following features or options:
• Stock Properties
• Advanced Stock Setup
TTiippss ffoorr UUssiinngg tthhee TTeesstt PPrriinntt OOppttiioonn
Before you use the Test Print option, review the following information.
• If multiple Stock Properties attributes or Advanced Stock Setup options are changed, then do
the following:
1. Change only one attribute or option
2. Run test prints
3. Evaluate the sample output
4. If the sample output is acceptable, then change a different attribute or option
5. Repeat the previous steps for evaluating the next attribute or option
• If the sample output is unacceptable after running test prints, do one of the following:
– Make further adjustments to the attribute or option and run more test prints, or
– Return the attribute or option to its default value and continue to the next attribute or option
• It is important to remember that any settings used today for a particular attribute or option
cannot achieve the same desired output when used on different day. This is especially relevant if
the room in which the press is located experiences changes in temperature and humidity
• Repeat the procedures continually and test prints for any attribute or option until you achieve
acceptable output prints
116
Xerox
®
Versant
®
4100 Press
User Documentation
Working With