SquareFold
®
Trimmer Paper Path
Number
Description
1 The booklet leaves the booklet area of the finisher and enters the SquareFold
®
Trimmer device. The booklet exit sensor, in the SquareFold
®
Trimmer device,
detects the lead-edge spine of the booklet and moves the booklet to the square-
fold area.
2 Once the booklet spine reaches the square-fold area, the booklet is clamped and
the square-folding operation begins.
3 The booklet is flattened and the spine squared according to the square-fold
setting indicated on the control panel.
4 After the booklet is flattened and the spine squared, it is moved to the trimmer
area.
• Based on the finished booklet size, the booklet is moved until the trail edge
reaches the trimmer cutter.
• The trail edge is trimmed (cut); this is based on the finished booklet size
entered for the trimmer mode setting.
5 The booklet is then moved to the exit area where it is transported to the booklet
tray.
Note: Booklets exiting the SquareFold
®
Trimmer device may contain trim remnants or scraps
from the previously trimmed booklet. This is due to static electricity build-up and is normal. If
booklets contain trim remnants or scraps, simply remove and discard them.
SSqquuaarree FFoolldd aanndd TTrriimm FFeeaattuurreess
Square Fold Feature
Press Square-fold button to adjust the thickness, the square-folding, of the printed booklets.
216
Xerox
®
Versant
®
4100 Press
User Documentation
Working With
To Next Page
Loading...
