• Do not attempt to remove paper that is jammed deeply inside the Press. Switch off the Press
promptly and contact your local Xerox representative.
• To avoid a tip hazard, do not push or move the device with all of the paper trays extended.
• Do not place the Press in locations susceptible to vibrations.
• For optimum performance, use the Press at the Altitude specified in Environmental Specifications
section of the User Documentation.
• Use the materials and supplies specifically designed for your Press. The use of unsuitable materials
may result in poor performance of the Press and possibly a hazardous situation.
• Follow all warnings and instructions that are marked on or supplied with the Press.
• Place the Press in a room that provides adequate space for ventilation and servicing.
• Place the Press on a level, solid surface, not on a thick pile carpet, that has adequate strength to
support the weight of the Press.
• Do not attempt to move the Press. A leveling device that was lowered when your Press was
installed may damage the carpet or floor.
• Do not set up the Press near a heat source.
• Do not set up the Press in direct sunlight.
• Do not store or operate the Press in an extremely hot, cold, or humid environment.
• Do not set up the Press in line with the cold air flow from an air conditioning system.
• Do not place containers of coffee or other liquid on the Press.
• Do not block or cover the slots and openings on the Press.
• Do not attempt to override any electrical or mechanical interlock devices.
Hot Warning: Be careful when working in areas identified with this warning symbol. These
areas may be very hot and should not be touched.
If you need any additional safety information concerning the Press or materials, contact your Xerox
representative.
OOzzoonnee IInnffoorrmmaattiioonn
This product produces ozone during normal operation. The ozone is heavier than air, and the quantity
is dependent on print volume. Install the system in a well-ventilated room.
For more information, refer to Facts about ozone and Fact about ventilation at www.xerox.com/EHS or
www.xerox.com/EHS-eu.
MMaaiinntteennaannccee IInnffoorrmmaattiioonn
Do not carry out any maintenance on this product which is not described in the customer
documentation.
WARNING: Do not use aerosol cleaners. Aerosol cleaners can be explosive or flammable when
used on electromechanical equipment.
Use supplies and cleaning materials only as directed.
Do not remove the covers or guards that are fastened with screws. Customer service items are not
14
Xerox
®
Versant
®
4100 Press
User Documentation
Learning About
To Next Page
Loading...
