3. Select either the New or Edit button.
If you edit an existing fold adjustment, select the desired profile from the list and then select the
Edit button.
The [New or Existing] Profile Properties window opens.
4. Type in a new name, or if needed, edit the existing name.
It is recommend that you use a name such as C Fold Plain or something that indicates the
fold type.
5. From the drop-down menu, select the C-Fold for the Fold Type.
6. Select desired settings such as Size and Weight.
7. Select the Test Print button.
The Fold Adjustment - Test Print window appears.
8. Select the desired tray, and then select the Start button.
After the test prints complete, the [New or Existing] Profile Properties window reopens.
Note: This screen varies depending on the selected Fold Type.
9. Obtain the printed samples from the output area of the press.
10. Measure the sample output and record both C-Fold positions on a sheet of paper.
11. Use the Up and Down Arrow buttons and enter the measurement value that you obtain during
the previous step in the A Length window and the B Length window.
12. To ensure that the fold positions are now correct, run more test prints.
a. Select the Test Print button.
b. Select the desired tray.
c. Select the Start button.
d. Obtain the printed samples from the output area of the press.
e. Measure the sample output and record both fold positions on a sheet of paper.
f. Enter the measurement A Length and B Length values.
g. Repeat the previous steps until the desired output is achieved.
13. When desired output is achieved, select OK to save and close the Fold Adjustment Profile.
Note: After multiple attempts, if acceptable output cannot be achieved, select OK to save
and close the profile. For further assistance, contact the Customer Support Center.
Z-Fold Adjustment Procedure
Note: The C and Z Fold Adjustments are available with a C/Z Folder device.
152
Xerox
®
Versant
®
4100 Press
User Documentation
Working With
To Next Page
Loading...
