Xerox Versant 4100 Press - Profiles

10. Review the output and choose one of the following:
• If paper curl still exists on the output:
1. Select another curl correction setting (Step 5).
2. Repeat Step 6 through Step 9.
3. Review the output and if paper curl still exists, repeat these steps again.
4. If the output still contains too much paper curl, change the print density or type of paper
used. If the results are still unsatisfactory, contact your Customer Support Center for
further assistance.
• If the output is acceptable, perform the following:
1. To save the selections or settings and close the Paper Curl Correction Test Print window,
select OK.
2. To save the selections or settings and close windows until only the Stock Library screen or
the Trays screen remains open, continue to select OK.
PPrrooffiilleess
The Profiles feature allows you to create and customize various profiles.
Alignment Profiles
Alignment Profiles allow you to position the output image to accommodate for misalignment or
skew. The profiles are used at the point of need for specialized print jobs.
Fold Adjustment Profiles
The Fold Adjustment feature allows you to adjust the fold position for various paper types, and set
adjustment values to various default types.
The Fold Adjustment feature is available when the press is connected to one of the following:
• For Bi-Fold or Single Fold options, an optional booklet maker finisher
• For C and Z Fold options, an optional finisher and the C/Z Folder device
Crease Adjustment Profiles
The Crease Adjustment feature allows you to adjust the crease position for various paper types,
and set adjustment values to various default types.
Use of the Crease Adjustment feature requires an optional Crease and Two-Sided Trimmer
module.
Third-party Finishing Devices
For systems which have a third-party, Digital Finishing Architecture (DFA) device attached, a
Finisher Profile is available.
Access the Finisher Profile from the press control panel when logged in as Administrator by
selecting Tools→Maintenance→Finisher Adjustment→DFA Finisher Profiles.
Note: For more information, refer to the System Administrator Guide.
Xerox
®
Versant
®
4100 Press
User Documentation
135
Working With