Xerox Versant 4100 Press - SquareFold Trimmer Circuit Breaker

Number
Component Description
1 Left Cover * Open this cover to remove paper jams.
2 Right Cover * Open this cover to remove paper jams.
3 Circuit Breaker Switch on the rear of
device
Automatically shuts off electricity in the event
of an electrical fault or a short circuit.
4 Booklet Tray This tray receives square-fold booklet output
from the finisher.
5 Square-fold Adjustment Button Press this button to adjust the thickness of
printed booklets.
6 Paper Jam and Error Indicator Lights when a paper jam occurs.
7 Trimmer Waste Container Collects waste from the trimmer area of the
device.
* The covers cannot be opened during normal operation or when the press is idle. The covers can be
opened only when an indicator is lit and a jam or fault occurs within the SquareFold
®
Trimmer
device.
SquareFold
®
Trimmer Circuit Breaker
The circuit breaker is located on the rear of the device. The circuit breaker is normally in the ON
position.
Note: When an electrical interruption is detected, the circuit breaker automatically switches off
to discontinue the electrical flow to the device. For electrical information, refer to Safety.
Under normal operating conditions, this switch should not be touched. If the press is moved, press
this button to switch off power to the device.
214
Xerox
®
Versant
®
4100 Press
User Documentation
Working With