Xerox Versant 4100 Press - Stacker Tray; Booklet Tray

A B
Default, lower angle Raised, upper angle
To change the angle of the tray:
1. Pull the top tray from the lower seating (A) by pulling it toward the right.
2. Insert the clutches at the lead edge of the tray into upper seating (B).
Stacker Tray
Side stitch jobs are delivered to this tray only.
Note: Delivering 2,000 or more sheets to this tray with excessive downward curl may cause the
output stack to fall out of the tray. If this happens, set the curl correction level on the Interface
Decurler Module to its lowest level and set curl correction on the Inserter setting to downward.
For information, refer to Paper Curl Correction with the PR Finishers.
Booklet Tray
Note: The booklet tray is attached to PR Booklet Maker Finisher. However, if the SquareFold
Trimmer is installed, the booklet tray is attached to SquareFold Trimmer.
Bi-Fold and Bi-Fold with Saddle Stitch jobs are delivered to this tray only.
206
Xerox
®
Versant
®
4100 Press
User Documentation
Working With