Entire staple raised up Staple raised up with center pressed inward
Important:
• Depending on the type of paper being stapled, the staple nails may be bent. If the bent nails are
stuck inside the finisher, they may eventually cause paper jams.
• When you open the cover of the staple cartridge, remove any bent staples; otherwise staple jams
may occur. Use the cover of the staple cartridge only when removing jammed staples.
Clearing Staple Jams in the Basic Stapler
If the staple cartridge accidentally detaches from its holder, refer to Reinserting the Basic Staple
Cartridge.
Note: Ensure that the press is not running before performing this procedure.
1. Open the finisher front cover.
Xerox
®
Versant
®
4100 Press
User Documentation
411
Troubleshooting
To Next Page
Loading...
