located behind these covers.
Note: Your Xerox Production Press is equipped with an power saving device to conserve power
when the Production Press is not in use. The Production Press can be left on continuously.
Hot Warning: The metallic surfaces in the fuser area are hot. Use caution when you remove
paper jams from this area and avoid touching any metallic surfaces.
VVaaccuuuumm CClleeaanneerr UUssee ffoorr DDrryy IInnkk//TToonneerr SSppiillllss
Use a broom or a wet cloth to wipe off spilled dry ink/toner. Sweep slowly to minimize generation of
dust during clean up. Avoid using a vacuum. If a vacuum must be used, the unit should be designed
for combustible dusts (for example, explosion rated motor and non-conductive hose).
CCoonnssuummaabbllee IInnffoorrmmaattiioonn
WARNING: Use of non-Xerox supplies is not recommended. The Xerox Warranty, Service
Agreement, and Total Satisfaction Guarantee do not cover damage, malfunction, or
degradation of performance caused by use of non-Xerox supplies, or the use of Xerox supplies
not specified for this Production Press. The Total Satisfaction Guarantee is available in the
United States and Canada. Coverage can vary outside these areas. For more details, contact
your Xerox representative.
WARNING: When handling cartridges such as ink or fuser, avoid skin or eye contact. Eye
contact can cause irritation and inflammation. Do not attempt to disassemble the cartridge.
This can increase the risk of skin or eye contact.
Store all consumables in accordance with the instructions given on the package or container.
Keep all consumables away from the reach of children.
Never throw dry ink/toner, print cartridges, or dry ink/toner containers into an open flame.
For information on Xerox
®
supplies recycling programs, go to:
• For the United States or Canada: www.xerox.com/recycling
• For Europe and other markets: www.xerox.com/recycling-eu
BBaatttteerryy SSaaffeettyy
One or more circuit boards in this printer contain a lithium battery.
Do not attempt to repair or replace the lithium battery. If there is a problem with the battery, contact
an authorized service representative to correct the problem.
The lithium battery in this printer contains Perchlorate material. For information about the special
handling procedures associated with Perchlorate material, refer to www.dtsc.ca.gov/hazardouswaste/
perchlorate.
WARNING: If the battery on a circuit board is installed incorrectly, there is a risk of explosion.
Xerox
®
Versant
®
4100 Press
User Documentation
15
Learning About
To Next Page
Loading...
