Xerox Versant 4100 Press - Replacing the Suction Filter

b. Continue slowing pulling out the bottle from the press until it is completely removed.
Caution: Never use a vacuum cleaner when cleaning up any spilled dry ink / toner. Use
a broom or a cloth moistened with a neutral detergent.
5. Place the full waste bottle into the plastic bag provided with the bottle.
6. Remove a new, empty waste bottle from the packaging.
7. Hold the center part on the top of a new bottle and insert it gently into the press until it comes to
a stop.
8. Close the center front door.
Note: After you replace the dry ink/toner waste bottle, the system automatically resets the
High Frequency Service Item (HFSI) usage counter for this CRU component to zero (0).
Check the consumables Supply screen to verify the reset.
RReeppllaacciinngg tthhee SSuuccttiioonn FFiilltteerr
Important: Before performing this procedure, ensure that you have the required T10 Torx
driver tool.
After replacing the filter, contact the system administrator. The administrator must log into
administrator mode and reset the High Frequency Service Item (HFSI) counter for this CRU to zero
(0).
Caution: Make sure the press is powered off before performing this procedure.
1. At the back of the press, locate the suction filter cover on the lower panel.
252
Xerox
®
Versant
®
4100 Press
User Documentation
Working With