6. Push the Saddle Stitch Unit 3 gently into the finisher until it stops.
7. Close the finisher front cover.
Stapler Faults in the PR Finisher Plus
Refer to the following procedures for clearing staple jams the PR Finisher Plus, Basic Staple Cartridge:
• Finisher Staple Faults
• Clearing Staple Jams in the Basic Stapler
• Reinserting the Basic Staple Cartridge
FFiinniisshheerr FFaauulltt MMeessssaaggeess
When a fault occurs, such as paper jams, open doors or covers, or a press malfunction, the press stops
printing and a message appears on the press touch screen. A graphical illustration shows the location
of the fault with a brief explanation of corrective actions for clearing the fault. If a fault occurs in
more than one location, the illustration changes to indicate the multiple locations and the required
corrective actions.
The touch screen also displays a Faults button which provides information about the fault and
detailed instructions for correcting the fault. The (E) code on the upper-left part of the Fault message
displays which error indicator is lit on the Finisher indicator panel (E1–E9).
Finisher Fault Code Information
When a fault occurs, such as paper jams, open doors or covers, or a press malfunction, the press stops
printing and a message appears on the press touch screen.
The touch screen also displays a Faults button which provides information about the fault and
detailed instructions for correcting the fault.
Tip: Finisher faults are identified by the codes which start with the three-digit numbers 012,
013, 024, 041, 112, and 124.
Xerox
®
Versant
®
4100 Press
User Documentation
417
Troubleshooting
To Next Page
Loading...
