• Long Edge Feed or Short Edge Feed
5. Select Start to run the test prints.
6. Retrieve your printed output, and discard the first few prints as inconsistency tends to be
greater with these first images.
7. Evaluate the test prints by holding the output at eye level near a light source. This allows
you to see the registration marks for side 1, and side 2 (if 2 sided output was selected).
Choose one of the following:
• If the alignment on the output is acceptable, continue to the next step.
• If the alignment between side 1 and side 2 continues to be unacceptable, contact the
Customer Support Center for further assistance.
17. Select OK to save and close the alignment Profile Properties window.
The new or edited profile procedure (for example, AlignmentProfile2) is displayed on the
Alignment window and can be selected at any point of need in the future.
Creating or Editing an Alignment Profile
Use the following procedure to create a new or edit an existing alignment profile for adjusting Side 1
and Side 2 image output.
Use the following procedure to create a new or edit an existing alignment profile for adjusting Side 1
and Side 2 image output.
1. From the PredictPrint Media Manager main window, select Profiles.
The Profiles window appears.
2. Ensure that the Alignment tab is displayed.
Alignment should be the first tab displayed after selecting Profiles from the PredictPrint Media
Manager main window.
3. Select New or Edit to create a new alignment profile or to edit an existing alignment profile.
Either the New Profile Properties or the Edit Profile Properties window opens.
4. If desired, enter a new name or modify the existing name.
5. Select and edit an alignment profile option (Registration, Perpendicularity, Skew, or
Magnification), and make the desired selections for that option.
Tip: When adjusting multiple items, adjust the image in the following order: Registration,
Perpendicularity, Skew, and finally Magnification.
6. Select the Test Print button.
The Test Print window appears.
7. Select the desired Test Print options, including:
a. For the Test Pattern, select PH-Regi
b. The desired paper tray
c. Print quantity
It is recommended that you select a quantity of 10 test prints in order to best evaluate the
printed output.
d. Long Edge Feed or Short Edge Feed
Xerox
®
Versant
®
4100 Press
User Documentation
143
Working With
To Next Page
Loading...
