• Use the following sequential order when making changes to the paper curl. This ensures that
the desired output is achieved:
a. Default
b. Type A
c. Type B
d. Type C
e. Custom Curl Correction: Slight (Very Small) Upward or Slight (Very Small) Downward
f. Custom Curl Correction: Moderate (Small) Upward or Moderate (Small) Downward
g. Custom Curl Correction: Medium Upward or Medium Downward
h. Custom Curl Correction: Severe (Large) Upward or Severe (Large) Downward
For more information, refer to Types A, B, and C.
Tip: Paper jams and wrinkled output may occur if the change is not performed in
the recommended sequential order; for example, using Default and then skipping to
Type C.
Note: Always run test prints every time a setting is changed or selected; this allows
you to evaluate the output and determine if additional changes are necessary.
• If paper curl continues to persist after trying several or all of these settings, try decreasing the
image density on the print job or use a different type of paper.
• If paper curl is still a problem after decreasing the image density and after using a different
type of paper, contact the Customer Support Center for further assistance.
For more information, refer to the Paper Curl Correction
UUnneevveenn DDeennssiittyy oorr MMoottttllee
Problem
Uneven Density or Mottle
Solutions
1. Perform Secondary Transfer Voltage Adjustment.
• Use this feature to adjust the voltage ratio on the secondary bias transfer roll (2
nd
BTR). For
heavy-weight paper, such as 220 g/m
2
or greater, the 2
nd
BTR is where the image is transferred
from the belt to the paper. However there are times when it is also used with lightweight
paper.
• This feature is accessed from PredictPrint Media Manager→Stock Library→Stock
Properties→Advanced Setup→Secondary Transfer Voltage Adjustment.
Xerox
®
Versant
®
4100 Press
User Documentation
307
Troubleshooting
To Next Page
Loading...
