or stock (such as coated or silk media), and the fuser temperature can be too low or too high.
• The temperature of the fuser can be adjusted within a range of -10° to +10° Celsius (14° - 50°
Fahrenheit).
• The default setting is 0 (zero). It is recommended that you leave this option at its default setting
until you run test prints and evaluate the output of the prints.
• Changing the default setting is considered as a temporary solution because environmental
conditions vary from day to day. It is recommended that upon completion of the print job, you
return the option to its default setting.
Fuser Speed Adjustment
This option allows the user to adjust the fuser speed for when there is a smear on the output print at
208 mm from the lead edge. This smear is caused by a speed mismatch between the paper lead edge
in the fuser nip and the middle of the paper in the Second Transfer nip.
If this smear occurs on the output print (at 208 mm from lead edge), the fuser speed can be
increased (up to +2 or 3%). This helps to correct this defect.
Alignment Profile
Selecting the Alignment Profile button opens the Alignment Profile Library. This library is populated
with all the saved alignment profiles for the system. A user can select a desired profile, as required.
The selected profile then appears in the Alignment Profile field which is above the button.
All fold adjustment profiles are created and maintained from the Profiles feature on the PredictPrint
Media Manager on the print server.
For detailed information and instructions, refer to Profiles feature and Alignment Profiles option.
Alignment Profile Library
The Alignment Profile Library is populated with all the saved alignment profiles for the system. A
user can select a desired profile to use at point of need.
The Alignment Profile Library can be accessed from Tray Properties and from Advanced Stock
Setup.
Note: Alignment profiles cannot be created or edited from the library. To create or edit profiles,
from the PredictPrint Media Manager main window, select Profiles→Alignment Profile.
Fold Adjustment Profile
Note: The Fold Adjustment feature is available when the press is connected to an optional
booklet maker finisher (for Bi-Fold or Single Fold), or when the press is connected to both an
optional finisher and the C/Z Folder device.
Selecting the Fold Adjustment Profile button opens the Fold Adjustment Profile Library. This library
is populated with all the saved fold profiles for the system. A user can select a desired profile, as
required. The selected profile then appears in the Fold Adjustment Profile field which is above the
button.
All fold adjustment profiles are created and maintained from the Profiles feature on the PredictPrint
Media Manager on the print server.
For detailed information and instructions, refer to Profiles feature and Fold Adjustments option.
124
Xerox
®
Versant
®
4100 Press
User Documentation
Working With
To Next Page
Loading...
