Item
Specification
Width 7.2–19.2 in.
182.0–488.0 mm
Paper weight Top Tray 52–400 g/m
2
Stacker tray or
cart
52–400 g/m
2
, coated and uncoated
HCS Media Guidelines
• Stacker tray/cart accepts 52–400 g/m
2
coated or uncoated stock with the possibility of degraded
stack quality and increased jam rate for stocks that are heavier than 300 g/m
2
.
• Transparencies may be run to the top tray or to the stacker tray/cart. Stack height should be
limited to 100 transparencies.
• Coated paper lighter than 100 g/m
2
may not run as reliably as coated paper heavier than 100 g/
m
2
.
• Non-standard papers longer than 305 mm (12 in.) in the feed direction require 210 mm (8.3 in.)
minimum measurement across the feed direction.
• Non-standard papers shorter than 254 mm (10 in.) in the cross-feed direction require 330 mm (13
in.) minimum measurement in the feed direction.
CCrreeaassee aanndd TTwwoo--SSiiddeedd TTrriimmmmeerr
Note: This optional finishing device requires the Interface Decurler Module.
The Crease and Two-Sided Trimmer is an optional finishing device that provides trimming on two
sides of the output.
• Trims 6–25 mm (0.24–0.99 in.) from the top and bottom of prints or booklets to produce an even
edge.
• When paired with the SquareFold
®
Trimmer, all sides of booklets are trimmed except the binding,
which enables full-bleed booklets. For more information, refer to SquareFold
®
Trimmer Device.
• Trims paper sizes 182 x 257–330 x 488 mm (7.2 x 10.1–3 x 19.2 in.). If the trimmed output is for
booklet making, the minimum paper size is 194 x 257 mm (7.6 x 10.1 in.).
• Handles uncoated and coated paper 52–350 g/m
2
.
196
Xerox
®
Versant
®
4100 Press
User Documentation
Working With
To Next Page
Loading...
