Xerox Versant 4100 Press - Auto Alignment Procedure; Using Manual Test Print for an Alignment Profile

1. Load the appropriate stock into the desired tray.
2. Print a sample output and verify for any misalignment of the output image.
3. If the output image is misaligned, perform the Auto Alignment Procedure procedure.
Auto Alignment Procedure
The Auto Alignment option automatically performs corrective registration, perpendicularity, skew,
and magnification adjustments.
Before you perform the following steps, perform the Pre-alignment Procedure
1. From the PredictPrint Media Manager main window, select Profiles.
The Profiles window appears.
2. Ensure that the Alignment tab is displayed.
Alignment should be the first tab displayed after selecting Profiles from the PredictPrint Media
Manager main window.
3. Select New or Edit to create an alignment profile or to edit an existing alignment profile.
Either the New Profile Properties or the Edit Profile Properties window opens.
4. If needed, enter a new name or modify the existing name.
5. Select the Auto Alignment button.
The Test Print window for Auto Alignment opens.
6. Select the appropriate tray and profile name.
7. Select the desired Front and Back Print Density Levels.
The Front and Back Print Density Levels are available only with the Grid 90 - Front & Back Test
Print. This is the default test print that the Alignment feature uses.
8. Select the Start button.
• The press runs a test print and performs the automatic adjustments.
• When the press completes the test print, the following message appears: Examine the
test print. If the print alignment is an improvement, click "OK" to
accept the new settings. If the alignment isn't an improvement, click
"Cancel" to revert to the original settings.
• Before you select either OK or Cancel, continue to the next step.
9. Review the test print output and choose one of the following:
• The test print output is an improvement and is acceptable, perform the following:
1. Select OK to close the Auto Alignment - Confirmation window.
2. Select OK to save and close the New Profile Properties or the Edit Profile Properties
window.
3. Select Close to exit Profiles and return to the PredictPrint Media Manager main window.
• The test print output is not an improvement and is not acceptable. Select Cancel to close the
Auto Alignment - Confirmation window and perform the procedure entitled Using Manual
Test Print for an Alignment Profile.
Using Manual Test Print for an Alignment Profile
Before you perform the following steps, perform the Pre-alignment Procedure
140
Xerox
®
Versant
®
4100 Press
User Documentation
Working With