2. Press the Power button on top of the press to the ON position.
The Ready Indicator light displays green.
A screen message advises of a short wait while the fuser warms up and the press runs a system
check. You can set features for a job during this time and the printing process will start
automatically when the press is ready.
3. To switch off, press the Power button to the Off position.
Note: Allow the press to remain off for a minimum of 10 seconds before switching on the
power again.
PPoowweerr SSaavveerr MMooddee
The Power Saver feature allows the press to enter a reduced power consumption mode when all print
jobs have completed and there are no jobs currently processing. There are two power saving modes:
Low Power and Sleep.
• Low Power: After remaining inactive for a preset time period, the press enters the Low Power
mode.
• Sleep: After entering Low Power mode and remaining inactive for another preset time period, the
press enters the Sleep mode.
By default, the press automatically enters the Low Power mode after 15 minutes of inactivity. After
30 minutes of inactivity, the press then enters Sleep mode. These time intervals for both modes can
be changed by the system administrator.
Refer to the following example:
• Low Power Mode is set to 1 minute.
• Sleep Mode is set to 10 minutes.
• Sleep Mode activates after 10 minutes of total inactivity, and not 10 minutes after the Low Power
Mode begins.
LLooww PPoowweerr MMooddee
In this mode, the power to the Control Panel and fuser unit is lowered to save power. The display goes
out and the Power Saver button on the Control Panel lights.
To exit the Low Power Mode, press the Power Saver button. The Power Saver button is no longer lit,
indicating that the Power Saver feature is canceled.
SSlleeeepp MMooddee
In this mode, the power is lowered more than in the Low Power mode. The display goes out and the
Power Saver button on the Control Panel lights.
To exit the Sleep Mode, press the Power Saver button. The Power Saver button is no longer lit,
indicating that the Power Saver feature is canceled.
EExxiittiinngg PPoowweerr SSaavveerr MMooddee
The press exits Power Saver mode by pressing the Power Saver button on the Control Panel or when
receiving print data from an incoming job.
44
Xerox
®
Versant
®
4100 Press
User Documentation
Working With
To Next Page
Loading...
